The use of diamond repair tools should be done and should not do:
1 before using the new dresser, the feed from the last trim should exit. Many brittle diamond dressing tools, in contact with the wheel, are easily damaged.
2 the tool head of diamond dressing tool is installed at the angle of 10-15 angle, and the rotation direction of the wheel is pointed..
3 firmly install the dresser or clamp the dressing tool, and may not hang the tool head too long.
4 as far as possible, use coolant as far as possible.. During the dressing time, the coolant pouring dressing tool and the grinding wheel contact.
5 at the beginning of the dressing, the highest point from the grinding wheel is repaired, usually for the middle part of the grinding wheel..
6 pay attention to the minor repair except for. The maximum depth of repair except: 0.001-0.002 inch. In addition to finishing: 0.0005-0.001.
7 select the appropriate horizontal movement speed according to the relevant manual.. The slower the lateral movement speed (the allowable range), the lower the roughness of the grinding wheel..
8, the grinding wheel can be trimmed in the specified time interval to prevent the grinding wheel from blunt and increase the grinding force..
9 in the time interval, the cutter clip in the dressing tool, rotating 1 / 8 laps, to ensure that the dressing tool always sharp.
10 when the diamond dresser or tool head becomes dull or visibly changed, it should be adjusted and replaced in time..
11 according to the diameter of the grinding wheel, the amount of CARAT (pure diamond content), the greater the diameter of the wheel, the greater the CARAT value of the diamond, is selected.